![]() so when inserting the denon pra 6000 in your system be sure to check the signal absolute phase on your speakers cables. The signal phase is the opposite of the phase on the kenwood.(wich one is inverting wich one is non inverting?) this is obvious and it affects a lot the sound. It is a pre-pre-amp with a configuration alike the NPN-half of the Fig. On the technical side: the boards are very crowdy and the caps run hot inside, i had to changed some. thus, MC cartridges like the Denon DL 103 R could be connected, according to. i use it with sony MC 44XL and a denon DL 110. Looking to upgrade my Denon AVR right now and my current thoughts are to buy a Denon AVR-X3900 (use pre-outs only) and an Emotiva XPA-7 Gen3 power amp, which can supply 200w into 7 channels simultaneously. same sound signature but very nice with old vinyls. can't really says more about it because no other preamp to compare it with. The denon is more subtle, more detailed may be but i am using more the kenwood for everyday listening.Ībout the phono section: it is very good and quiet and has a lot of gain. it has this constantly liquid, sweet, never hard sound of classA and while very ear friendly does not have the sense of service and transparency that has my modified kenwood 700C. This is a very sweet sounding preamp in the sense that there is no harshness at all and very very low distorsion.įor the cons: it has a sound of itself while neutral in the overall tonal balance it is very depending of the associated equipement also. Submitted by Stephen300 on December 12th, 2019. Its not a bad product but it is certainly not the reference. My hand build Pre amp sounds much better. Highs are very clean, it is striking when coming from another preamplifier, macro and microdynamics are very good but benefits a lot from changing the big power caps (on my unit i used some BHC SLIT FOIL caps and this is huge change over the previous old caps especially in dynamics and bass) Stereo Pre Amplifier (1990-95) (2 reviews) Specifications. bass is a bit round but deep and amazingly light (in a sense that it makes the bass involving not repetitive) very low distorsion, lots of details but it softens the edges a bit. in fact this preamp is quite neutral, slightly going on the warm side after 2 hours of use. i can't say that the sound is hot but it has typical sound characteristics of classA. thus the sound is changing when cold and when warmed up. this is a class A preamp and it runs hot. My unit is 100V and works fine with a japanese step upĪbout the sound. the side are not as golden as it appears on the promotional picture or in TVK. I am using a denon pra6000 for one year and a half. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |